Quiescent current S...
 
Share:
Notifications
Clear all

Quiescent current Solvsuper 12

5 Posts
3 Users
2 Reactions
2,658 Views
Pawel
(@pawel)
Member Moderator
Joined: 4 years ago
Posts: 116
Topic starter  

Hello

I cannot find any info how much the quiescent current should be and what points are used to set it up. Thanks for help !

 

Pawel


   
Quote
(@mrtron)
Active Member
Joined: 4 years ago
Posts: 9
 

I happened upon the following information on a Facebook group for Tandberg repair. My translation below is accurate, but I give no guarantees that the information is correct:

“The SS12 circuit diagram states a 0.015V voltage drop across R837-8  This gives a quiescent current of 32mA. Hence, adjust the quiescent current until the voltage across these resistors is 15 mV.”


   
Tandbergista reacted
ReplyQuote
Pawel
(@pawel)
Member Moderator
Joined: 4 years ago
Posts: 116
Topic starter  

@MrTron thanks a lot , I set up 12mV as I recal so I was close 🙂 

Pawel


   
MrTron reacted
ReplyQuote
(@keithbook)
New Member
Joined: 3 years ago
Posts: 1
 

Hi....the 470k pot ought to change the mid point voltage, which as indicated by the schematic you posted ought to be 13 volts at the intersection of R532 and C519.

The 1k pot ought to change the peaceful current for the yield pair whatever that current should be, there's no sign of that in the schematic you've posted, as an estimate I would say somewhere near 8mA without any cited figure.


   
ReplyQuote
Pawel
(@pawel)
Member Moderator
Joined: 4 years ago
Posts: 116
Topic starter  

OK, thanks ! 

Pawel


   
ReplyQuote
Share:

This website uses cookies. By continuing to use this site, you accept our use of cookies.